FSCK(8) UNIX Programmer's Manual FSCK(8) NAME fsck - file system consistency check and interactive repair SYNOPSIS fsck -p[ # ] [ filesystem ... ] fsck [ -y ] [ -n ] [ -sX ] [ -SX ] [ -t filename ] [ filesystem ] ... DESCRIPTION The first form of _f_s_c_k preens a standard set of file systems or the specified file systems. It is normally used in the script /_e_t_c/_r_c during automatic reboot. In this case _f_s_c_k reads the table /_e_t_c/_f_s_t_a_b to determine which file systems to check. It uses the information there to inspect groups of disks in parallel taking maximum advantage of i/o overlap to check the file systems as quickly as possible. Normally, the root file system will be checked on pass 1, other ``root'' (``a'' partition) file systems on pass 2, other small file systems on separate passes (e.g. the ``d'' file systems on pass 3 and the ``e'' file systems on pass 4), and finally the large user file systems on the last pass, e.g. pass 5. Only one file system from each disk should be checked in each pass. A pass number of 0 in fstab causes a disk to not be checked; similarly partitions which are not shown as to be mounted ``rw'' or ``ro'' are not checked. A number or range of numbers may be given after the -p to start or end the check at a specified pass number. A single number specifies the starting pass (e.g. -p2 or -p2-); a range specifies the starting and endig passes (-p2-4). A missing start means to start with pass 1 (-p-2). These can be used to stop fsck to mount a temporary file system before continuing the check on larger file systems requiring scratch files. The system normally takes care that only a restricted class of innocuous inconsistencies can happen unless hardware or software failures intervene. These are limited to the fol- lowing: Unreferenced inodes Link counts in inodes too large Missing blocks in the free list Blocks in the free list also in files Counts in the superblock wrong Allocated inodes in the free inode list Printed 11/26/99 1 FSCK(8) UNIX Programmer's Manual FSCK(8) These are the only inconsistencies which _f_s_c_k with the -p option will correct; if it encounters other inconsistencies, it exits with an abnormal return status and an automatic reboot will then fail. For each corrected inconsistency one or more lines will be printed identifying the file system on which the correction will take place, and the nature of the correction. After successfully correcting a file system, _f_s_c_k will print the number of files on that file system and the number of used and free blocks. Warning: kernel changes are required to limit the types of inconsistencies, and fsck -p makes assumptions about the kernel's actions in repairing these. Vmunix, PDP-11 2.9BSD with the UCB_FSFIX option and PDP-11 2.10BSD Unix kernels have the appropriate modifica- tions; the -p option should not be used on other systems. Without the -p option, _f_s_c_k audits and interactively repairs inconsistent conditions for file systems. If the file system is inconsistent the operator is prompted for concurrence before each correction is attempted. It should be noted that a number of the corrective actions which are not fix- able under the -p option will result in some loss of data. The amount and severity of data lost may be determined from the diagnostic output. The default action for each con- sistency correction is to wait for the operator to respond yes or no. If the operator does not have write permission _f_s_c_k will default to a -n action. _F_s_c_k has more consistency checks than its predecessors _c_h_e_c_k, _d_c_h_e_c_k, _f_c_h_e_c_k, and _i_c_h_e_c_k combined. The following flags are interpreted by _f_s_c_k. -y Assume a yes response to all questions asked by _f_s_c_k; this should be used with great caution as this is a free license to continue after essentially unlimited trouble has been encountered. -n Assume a no response to all questions asked by _f_s_c_k; do not open the file system for writing. -s_X Ignore the actual free list and (unconditionally) reconstruct a new one by rewriting the superblock of the file system. The file system should be unmounted while this is done; if this is not possible, care should be taken that the system is quiescent and that it is rebooted immediately afterwards. This precau- tion is necessary so that the old, bad, in-core copy of the superblock will not continue to be used, or written on the file system. The -s_X option allows for creating an optimal free list organization. The following forms of _X are Printed 11/26/99 2 FSCK(8) UNIX Programmer's Manual FSCK(8) supported for the following devices: -s3 (RP03) -s4 (RP04, RP05, RP06) -sBlocks-per-cylinder:Blocks-to-skip (for anything else) If _X is not given, the values used when the file sys- tem was created are used. If these values were not specified, then the value _4_0_0:_9 is used. -S_X Conditionally reconstruct the free list. This option is like -s_X above except that the free list is rebuilt only if there were no discrepancies discovered in the file system. Using -S will force a no response to all questions asked by _f_s_c_k. This option is useful for forcing free list reorganization on uncontaminated file systems. -t If _f_s_c_k cannot obtain enough memory to keep its tables, it uses a scratch file. If the -t option is specified, the file named in the next argument is used as the scratch file, if needed. Without the -t flag, _f_s_c_k will prompt the operator for the name of the scratch file. The file chosen should not be on the file system being checked, and if it is not a special file or did not already exist, it is removed when _f_s_c_k completes. If no file systems are given to _f_s_c_k then a default list of file systems is read from the file /_e_t_c/_f_s_t_a_b. Inconsistencies checked are as follows: 1. Blocks claimed by more than one inode or the free list. 2. Blocks claimed by an inode or the free list outside the range of the file system. 3. Incorrect link counts. 4. Size checks: Directory size not 16-byte aligned. 5. Bad inode format. 6. Blocks not accounted for anywhere. 7. Directory checks: File pointing to unallocated inode. Inode number out of range. 8. Super Block checks: More than 65536 inodes. More blocks for inodes than there are in the file system. 9. Bad free block list format. 10. Total free block and/or free inode count incorrect. 11. Allocated inodes on the free inode list in the Printed 11/26/99 3 FSCK(8) UNIX Programmer's Manual FSCK(8) superblock. Orphaned files and directories (allocated but unreferenced) are, with the operator's concurrence, reconnected by placing them in the _l_o_s_t+_f_o_u_n_d directory. The name assigned is the inode number. The only restriction is that the directory _l_o_s_t+_f_o_u_n_d must preexist in the root of the file system being checked and must have empty slots in which entries can be made. This can be accomplished manually by making _l_o_s_t+_f_o_u_n_d, copying a number of files to the directory, and then removing them (before _f_s_c_k is executed). _M_k_f_s(8) will automatically create a _l_o_s_t+_f_o_u_n_d directory. Checking the raw device is almost always faster. The root device should not be checked using the raw device, however, since it cannot be unmounted. FILES /etc/fstab default list of file systems to check DIAGNOSTICS The diagnostics produced by _f_s_c_k are intended to be self- explanatory. The exit codes with the -p option are 0 (no problems that weren't fixed), 4 (root file system was modi- fied), 8 (problems that couldn't be fixed) and 12 (_f_s_c_k was interrupted). SEE ALSO filsys(5), fstab(5), crash(8), mkfs(8), mklost+found(8), reboot(8) T. J. Kowalski, _F_S_C_K - _T_h_e _U_N_I_X _F_i_l_e _S_y_s_t_e_m _C_h_e_c_k _P_r_o_g_r_a_m BUGS Inode numbers for . and .. in each directory should be checked for validity. Printed 11/26/99 4